Kurumun Atıf Alan Makalesi
Atıf Alan Yayın
Experimental study and analysis of machinability characteristics of metal matrix composites during drilling
Scopus
Toplam 130 atıf DOI
In this study, the metal matrix composite materials were produced by hot press with various production parameters. The drilling experiments were performed on computer numerical control vertical machining centre without cutting fluid. Analysis of variance (ANOVA) was carried out in order to determine the effects of the production parameters on thrust force and surface roughness of metal matrix composites drilled with different feed rate. The effect of production parameters such as temperature, pressure and reinforcement ratio were investigated, and their effects were presented. The optimal level for each production parameters was determined by ‘Maximize the S/N ratio approach with a Taguchi design’. The test results revealed that the reinforcement ratio was the main factor affecting the surface roughness of the metal matrix composites for both feed rate. However, same singularity was not matter on thrust force due to close contribution rates of production parameters and high error rates of analysis. In literature, an increase on the thrust force and the surface roughness values was reported as the feed rate increased during machining. Nevertheless, in our MMCs system, the thrust force and the surface roughness values were in tendency of declination as the feed rate increased which makes this study more novel research.
Atıf Kaynağı
Atıf Yapan Yayın
Investigation of signal behaviors for sensor fusion with tool condition monitoring system in turning
Scopus
Havuzumuzda 185 atıf almış
Monitoring of the cutting area with different type of sensors requires confirmation for composing sensor fusion to obtain longer tool life and high-quality product. The complex structure of machining and interaction between variables affect the influence of parameters on quality indicators. Using multiple sensors provide comparison of information acquired from different resources and make easier to decide about tool and workpiece condition. In this experimental research for the first time, five different sensors were adopted to a lathe for collecting data to measure the capability of each sensor in reflecting the tool wear. Cutting forces, vibration, acoustic emission, temperature and current measurements were carried out during turning of AISI 5140 with coated carbide tools. Considering the graphical investigation, the successes of sensors on detection of progressive flank wear and tool breakage were investigated. Besides, the effects of cutting parameters on measured variables were interpreted considering graphs. According to results, temperature and acoustic emission signals seem to be effective about 74% for flank wear. In addition, fuzzy logic based prediction of flank wear was performed with the assistance of temperature and acoustic emission sensors with high accuracy which demonstrates their availability for sensor fusion. Tool breakage occurs instantly which can prevent with the assistance of sensor signals and tangential and feed cutting forces, acoustic emission and vibration signals seem as reliable indicators for approaching major breakage. Sensor fusion based turning provides confirmed information which enables more reliable, robust and consistent machining.
Atıf Yapan Makale Bilgileri
Kurumlar (1)
Selçuk Üniversitesi
Selçuklu, Turkey