Kurumun Atıf Alan Makalesi
Atıf Alan Yayın
Experimental study and analysis of machinability characteristics of metal matrix composites during drilling
Scopus
Toplam 130 atıf DOI
In this study, the metal matrix composite materials were produced by hot press with various production parameters. The drilling experiments were performed on computer numerical control vertical machining centre without cutting fluid. Analysis of variance (ANOVA) was carried out in order to determine the effects of the production parameters on thrust force and surface roughness of metal matrix composites drilled with different feed rate. The effect of production parameters such as temperature, pressure and reinforcement ratio were investigated, and their effects were presented. The optimal level for each production parameters was determined by ‘Maximize the S/N ratio approach with a Taguchi design’. The test results revealed that the reinforcement ratio was the main factor affecting the surface roughness of the metal matrix composites for both feed rate. However, same singularity was not matter on thrust force due to close contribution rates of production parameters and high error rates of analysis. In literature, an increase on the thrust force and the surface roughness values was reported as the feed rate increased during machining. Nevertheless, in our MMCs system, the thrust force and the surface roughness values were in tendency of declination as the feed rate increased which makes this study more novel research.
Atıf Kaynağı
Atıf Yapan Yayın
The effects of mql and dry environments on tool wear, cutting temperature, and power consumption during end milling of aisi 1040 steel
Scopus
Havuzumuzda Open Access 105 atıf almış
Minimum quantity lubrication (MQL) is a sustainable method that has been efficiently applied to achieve machinability improvements with various materials in recent years, such as hardened steels, superalloys, soft metals, and composites. This study is the first to focus on the performance evaluation of MQL and dry milling environments with AISI 1040 steel. The tool wear, cutting temperature, and power consumption were considered as the quality responses while cutting speed, feed rate and machining environment are taken as input parameters. The effects of the influential factors are analyzed using analysis of variance (ANOVA) and bar charts. Additionally, Taguchi signal‐to‐noise (S/N) ratios are utilized in order to determine the optimum parameters for the best quality responses. The results show that the MQL system provides better performance compared to dry milling by reducing the tool wear, cutting temperature, and power consumption. According to the ANOVA results, the cutting environment affects the cutting temperature (37%) and power consumption (94%), while cutting speed has importance effects on the tool wear (74%). A lower cutting speed (100 m/min) and feed rate (0.10 mm/rev) should be selected under MQL conditions to ensure minimum tool wear and power consumption; however, a higher feed rate (0.15 mm/rev) needs to be selected along with a low cutting speed and MQL conditions to ensure better temperatures. A comparative evaluation is carried out on the tool wear, cutting temperature, and power consumption under MQL and dry environments. This investigation is expected to contribute to the current literature, highlighting the superiority of sustainable methods in the milling of industrially important materials.
Atıf Yapan Makale Bilgileri
Kurumlar (2)
Selçuk Üniversitesi
Selçuklu, Turkey
South Ural State University
Chelyabinsk, Russian Federation