Kurumun Atıf Alan Makalesi
Atıf Alan Yayın
The effects of stacking sequence on drilling machinability of filament wound hybrid composite pipes: Part-1 mechanical characterization and drilling tests
Scopus
Toplam 134 atıf DOI
In the first part of this two-part comprehensive study, mechanical properties and machinability characteristic of filament wound hybrid composite pipes with various stacking sequences of glass and carbon fibers (Glass-Carbon-Glass (GCG), Carbon-Glass-Glass (CGG), and Glass-Glass-Carbon (GGC)) were investigated experimentally. In order to determine the mechanical properties of the pipes, hardness test (Shore D), ring tensile test (ASTM D2290), and burst test (ASTM D1599) were carried out. Machinability tests were performed at various feed rates (50, 150, 250 and 350 mm/min) and spindle speeds (796, 1592, 2388 and 3184 rpm) using with and without a back-up. The results showed that stacking of the carbon layer between two glass layers (GCG) presented better performance in terms of mechanical properties and machinability characteristic. The maximum ring tensile stress of GCG specimen is 27% and 19% higher than those of GGC and CGG specimens, respectively. On the other hand, the lowest thrust forces measured during the drilling of GCG specimen while the GGC represented highest values. In addition, the use of back-up led to an increase in thrust force. The highest increase was observed in GGC sample. In GGC sample, a change in a spindle speed increased thrust force by 18–35%, while a change in feed rate increased thrust force by 20–30%.
Atıf Kaynağı
Atıf Yapan Yayın
Coating graphene nanoplatelets onto carbon fabric with controlled thickness for improved mechanical performance and EMI shielding effectiveness of carbon/epoxy composites
Scopus
Havuzumuzda Open Access 58 atıf almış
Coating nanostructures on fiber reinforcement is a facile and scalable technique to manufacture next-generation fiber-reinforced polymer composites with tailored physical properties. Optimizing the nanomaterial coating thickness on fibers is vital in tailoring the multifunctionality of fiber-reinforced composites without sacrificing the mechanical performance since it relies on the fiber–matrix interface, where interlaminar and other physical properties are governed. This paper investigates the impact of graphene nanoparticle (GNP) coating thickness on the mechanical properties, fracture behavior, thermo-mechanical, and electromagnetic interference (EMI) shielding effectiveness (SE) of composite structures. We grafted GNPs on carbon fabrics using a solution coating method with various thicknesses (10, 20, and 30 µm), and GNPs grafted fabrics were impregnated with an epoxy resin. The 20 µm GNPs coating thickness exhibited the highest mechanical performance, increasing the tensile and interlaminar shear strength by 32% and 26%, respectively, compared to pristine samples. Storage modulus and transition (Tg) temperature values increased by 18.6% and 13.6% for 20 µm coating thickness, respectively. Besides, the unstable crack growth at the fiber–matrix interface was stabilized when the GNPs coating thickness reached 20 µm according to delamination toughness tests. While mode-I fracture toughness increased up to 22%, an improvement of 13.5% was obtained in mode-II fracture toughness. The underlying toughening mechanisms at the interfacial region were identified using scanning electron microscopy. The EMI-SE was slightly increased by the GNPs grafting, whereas thinner GNPs coatings exhibited higher shielding efficiency.
Atıf Yapan Makale Bilgileri
Kurumlar (3)
Çanakkale Onsekiz Mart Üniversitesi
Canakkale, Turkey
Sabancı Üniversitesi
Tuzla, Turkey
Selçuk Üniversitesi
Selçuklu, Turkey