Kurumun Atıf Alan Makalesi
Atıf Alan Yayın
Evaluation of two post core systems using two different methods (fracture strength test and a finite elemental stress analysis)
Scopus
Toplam 193 atıf DOI
The aim of this study was to compare a fiber composite laminate (FCL) post core and a conventional cast post core system by using two different methods. The first method was a conventional fracture strength test, and the second was a finite elemental stress-analysis method (FEM). For the conventional fracture strength test, 20 extracted, human upper, central incisors were used. The teeth were decoronated, treated endodontically, and restored with two post core systems. After embedding the samples in resin blocks, a loading force was applied to the teeth at a crosshead speed of 5 mm/ min at an angle of 45 degrees to the long axis of the ooth. The data were recorded, and the results were compared by using the Mann-Whitney U test. There was no statistically significant difference between the two post systems (p>0.05). For FEM analysis, a pseudo three-dimensional model of a maxillary central incisor, theoretically restored with either a cast post or an FCL, was used. The analysis was performed by using the structural analysis program (SAP90). FEM analysis showed that stress was accumulated within the cast post core system, and transmission of stress to supportive structures and the tooth was low. This is an advantage for tooth and supporting tissues. When the FCL post core system was evaluated by FEM, the results indicated that this system transferr stress to supportive structures and the tooth while stress accumulation within the post system was low. This is an advantage for the restoration but disadvantage for the supporting tissues. Copyright © 2002 by The American Association of Endodontists.
Atıf Kaynağı
Atıf Yapan Yayın
The finite element analysis of the effect of ferrule height on stress distribution at post-and-core-restored all-ceramic anterior crowns
Scopus
Havuzumuzda 59 atıf almış
The purpose of this study was to compare the effect of ferrule with different heights on the stress distribution of dentin and the restoration-tooth complex, using the finite element stress analysis method. Three-dimensional finite element models simulating an endodontically treated maxillary central incisor restored with an all-ceramic crown were prepared. Three-dimensional models were varied in their ferrule height (NF: no ferrule, 1F: 1-mm ferrule, and 2F: 2-mm ferrule). A 300-N static occlusal load was applied to the palatal surface of the crown with a 135° angle to the long axis of the tooth. In addition, two post and core materials with different elastic modulus were evaluated. The differences in stress transfer characteristics of the models were analyzed. Maximum stresses were concentrated on force application areas (32.6-32.8 MPa). The stress values observed with the use of a 2-mm ferrule (14.1/16.8 MPa) were lower than the no-ferrule design (14.9/17.1 MPa) for both the glass fiber-reinforced and zirconium oxide ceramic post systems, respectively. The stress values observed with zirconium oxide ceramic were higher than that of glass fiber-reinforced post system. The use of a ferrule in endodontically treated teeth restored with an all-ceramic post-and-core reduces the values of von Mises stresses on tooth-restoration complex. At rigid zirconium oxide ceramic post system, stress levels, both at dentin wall and within the post, were higher than that of fiber posts. © Springer-Verlag 2008.
Atıf Yapan Makale Bilgileri
Kurumlar (1)
Selçuk Üniversitesi
Selçuklu, Turkey