Kurumun Atıf Alan Makalesi
Atıf Alan Yayın
Multi response optimisation of CNC turning parameters via Taguchi method-based response surface analysis
Scopus
Toplam 241 atıf DOI
This study presents a new method to determine multi-objective optimal cutting conditions and mathematic models for surface roughness (Ra and Rz) on a CNC turning. Firstly, cutting parameters namely, cutting speed, depth of cut, and feed rate are designed using the Taguchi method. The AISI 304 austenitic stainless workpiece is machined by a coated carbide insert under dry conditions. The influence of cutting speed, feed rate and depth of cut on the surface roughness is examined. Secondly, the model for the surface roughness, as a function of cutting parameters, is obtained using the response surface methodology (RSM). Finally, the adequacy of the developed mathematical model is proved by ANOVA. The results indicate that the feed rate is the dominant factor affecting surface roughness, which is minimized when the feed rate and depth of cut are set to the lowest level, while the cutting speed is set to the highest level. The percentages of error all fall within 1%, between the predicted values and the experimental values. This reveals that the prediction system established in this study produces satisfactory results, which are improved performance over other models in the literature. The enhanced method can be readily applied to different metal cutting processes with greater confidence. © 2012 Elsevier Ltd. All rights reserved.
Atıf Kaynağı
Atıf Yapan Yayın
Optimisation of parameters affecting surface roughness of Co28Cr6Mo medical material during CNC lathe machining by using the Taguchi and RSM methods
Scopus
Havuzumuzda 121 atıf almış
This study involves modelling of experimental data of surface roughness of Co28Cr6Mo medical alloy machined on a CNC lathe based on cutting parameters (spindle rotational speed, feed rate, depth of cut and tool tip radius). In order to determine critical states of the cutting parameters variance analysis (ANOVA) was applied while optimisation of the parameters affecting the surface roughness was achieved with the Response Surface Methodology (RSM) that is based on the Taguchi orthogonal test design. The validity of the developed models necessary for estimation of the surface roughness values (Ra, Rz), was approximately 92%. It was found that for Ra 38% of the most effective parameters is on the tool tip radius, followed by 33% on the feed rate whereas for Rz tool tip radius occupied 43% with the feed being at 33% rate. To achieve the minimum surface roughness, the optimum values obtained for spindle rpm, feed rate, depth of cut and tool tip radius were respectively, 318 rpm, 0.1 mm/rev, 0.7 mm and 0.8 mm.
Atıf Yapan Makale Bilgileri
Kurumlar (1)
Selçuk Üniversitesi
Selçuklu, Turkey